How To Perform Limb Bagging
Quick Guide To Ozone Limb Bagging
Duration: 20-30 minutes
Flow Rate: 1/4LPM (Setting 5 for Ozone+ Regulator)
Frequency: Daily or as needed
Limb Bag Setup
- Prepare ozone generator, oxygen tank, and oxygen regulator (refer to Section 1).
- Place limb into bag
- Determine inlet/outlet port placement
- Take limb out of bag
- Make small incision in bag where you will place inlet port
- Connect inlet port through incision
- Make small incision in bag where you will place outlet port
- Connect outlet port through incision
- Take silicone tubing (sold separately) and connect to the inlet port
- Take other end of tubing, connect to the top of ozone generator
- Take another piece of silicone tubing and connect to outlet port
- Take other end of tubing, connect to ozone destruct
Limb Bag Treatment
- Place limb into bag
- Tighten opening of bag with tourniquet to create seal
- Turn ozone generator on
- Set regulator to 1/4 LPM (Setting 5 for the Stratus 3.0 and Ozone+ Regulator)
- Allow to run for 20 – 30 minutes (Discontinue if needed)
- Set regulator to 0
- Turn ozone generator off


Download the FREE booklet